Go to main site 3dtek.xyz

Z axis auto Prob

Hi I have an GRBL AIO Configuration V1-I + board and want to install and setup Z axis auto Prob
Can some one tell me whats pins to use I cant seem to find any info on how to do this
thank you

This is how I wired mine. Not sure if it’s the same board. Hope it helps.

Thank you just seen message your picture helped a lot thank you

Where does one buy the Z-Axis auto probe??

EBay, Amazon, anywhere or you could make one , see you tube etc

Thanks for the tip, Phil.

Spent $12 with free postage on eBay. Works a treat!

Thank you for the Photo, Greg.

Made install for my ‘Z-Probe’ painless!

Hi,can you add the link to the probe you ordered from ebay.
Regards
Rodney