Go to main site 3dtek.xyz

Waste board - thickness and drilled holes - information please

I have started putting the XYZ together at last. My scrap board is 1000 x 940, but is made from plywood. It is 17.25mm thick. The instructions say 18mm. Will the 17.25mm thick be OK thanks.
Also do the drilled holes have to be as shown on the instructions diagram. I was intending to use 20mm holes throughout. UJK Parf guide system It that OK thanks.
Very excited to get this finished and cannot wait to see it all operating.
Thanks a lot for replies in advance.
Brad

Gday brad, this will be just fine! The threaded inserts can be drilled however you like. just follow the instructions for the fixing holes!