Go to main site 3dtek.xyz
Dust cover [Heavy Mill] (2)
How are the drag chains attached? [XYZ Carve] (3)
Super-PID [General] (2)
GRBLAIO Trimpot Settings [Heavy Mill] (3)
Belt Tension Trick [Heavy Mill] (2)
z axis only goes up even when pressing + or - [General] (3)
Are there any other Adelaide XYZ-Carve users? [General] (3)
A Great Experience [Heavy Mill] (1)
Protect your GRBL AIO [General] (4)
End bits 2 sided and 4 sided. [Heavy Mill] (3)
grbl firmware upgrade [XYZ Carve] (7)
GRBL AIO Alarm Lock [General] (5)
End mills [General] (8)
Request: photo of XYZ Carve drag change setup [XYZ Carve] (11)
Anyone use Linux to drive the xyz carve [XYZ Carve] (4)
Recommended Belt Tension [XYZ Carve] (6)
Controlling a Laser from GRBL AIO? [XYZ Carve] (6)
Brisbane area users [General] (1)
Does anyone have any Makerslide? [General] (2)
3 x email, and no reply..... [XYZ Carve] (6)
Any xyz carve or heavy mills for sale in Brisbane area.? [General] (1)
Anyone in Brisbane area with XYZ Carve? [XYZ Carve] (1)
GRBL AIO settings [XYZ Carve] (11)
Shapeoko 2 cuts 0.5mm short, checked everything! [General] (8)
Can't access any forum but "General" [General] (3)
GRBL v1.1 [Heavy Mill] (3)
Random Stopping during cut cycles [XYZ Carve] (3)
Cutting Acrylic [Heavy Mill] (8)
Heavy Mill GRBL Config Settings [Heavy Mill] (8)
Threaded Inserts, t-slot nuts and extrusions, where to buy locally and wasteboard sag? [XYZ Carve] (5)